Receipts / L15
Line by line
Every claim, with its source.
Sources were fetched on 2026-10-20.
Source key
- WP-MW: Wikipedia, "Multiway switching", section "Three-way (SPDT) switches". https://en.wikipedia.org/wiki/Multiway_switching
- WP-LS: Wikipedia, "Light switch", section "Multiway switching". https://en.wikipedia.org/wiki/Light_switch
| Shot / text | Claim | Source and verbatim support |
|---|---|---|
| hook "HOW CAN TWO SWITCHES RUN ONE LIGHT?" | Two switches can control one light, e.g. at two ends of a hallway. | WP-LS: "Two or more light switches can be interconnected to allow control of lighting from, for example, two ends of a long hallway". |
| each switch is one lever with a common terminal and two travelers | A "3-way" switch is a single-pole, double-throw (SPDT) switch. | WP-MW: "a typical '3-way' switch is a single pole, double throw (SPDT) switch." |
| power enters switch A's common; the lamp hangs off switch B's common | Hot goes to one switch's common terminal and the lamp to the other's. | WP-MW: "the power line (hot, shown in red) is fed into the common terminal of one of the switches", and the lamp connects to the common terminal of the other switch. |
| WIRE 1 / WIRE 2 between the switches | The two switches are linked by a pair of wires called travelers. | WP-MW: "a pair of wires called 'travelers.'" |
| lever flips between WIRE 1 and WIRE 2 | Flipping a switch disconnects one traveler and connects the other. | WP-MW: flipping a switch "disconnects one 'traveler' terminal and connects the other." |
| either switch changes the light | Toggling either switch changes the load from off to on, or vice versa. | WP-MW: "toggling either switch changes the state of the load from off to on, or vice versa." |
| answer "IT'S ON WHEN BOTH SWITCHES USE THE SAME WIRE" | The light is on only when both levers sit on the same traveler. | Follows from the circuit above: current reaches the lamp only if switch A's lever and switch B's lever touch the same traveler wire. (Derived from the wiring in WP-MW, not quoted.) |
What the drawing simplifies
- Schematic, not to scale; real switches are mains-voltage devices with terminals inside a box, and terminal positions vary by brand.
- The drawing shows the lever flipping about once every 90 frames (about 3 s). Real switches flip instantly.
- No quantities on screen, so no unit conversions.
Sources
Found an error?
Tell us at hello@workingshown.xyz or in the comments. We check it against the sources, pin the correction, fix the caption, and log it on the corrections page.
