Receipts / L18
Line by line
Every claim, with its source.
Sources were fetched on 2026-10-20.
Source
- WP-CL: Wikipedia, "Clutch". https://en.wikipedia.org/wiki/Clutch
| Shot / text | Claim | Source and verbatim support |
|---|---|---|
| hook "WHAT DOES THE CLUTCH PEDAL ACTUALLY DO?" / answer "IT DISCONNECTS THE ENGINE FROM THE WHEELS" | In a car the clutch links the engine to the transmission; the pedal disconnects them. | WP-CL: "the clutch acts as a mechanical linkage between the engine and transmission"; the clutch lets the output shaft be disconnected from the rotating input shaft. |
| spring + friction disc against flywheel | A friction disc is pressed against the flywheel by a spring mechanism; power flows only while they are in contact. | WP-CL: "a friction disk presses against a car engine's flywheel by a spring mechanism". |
| pedal down, disc pulled away | Pressing the pedal moves the friction disc away from the flywheel by a lever mechanism, which stops power transfer. | WP-CL: "the friction disk is moved away from the flywheel by means of a lever mechanism". |
| engine keeps turning while the shaft is still | With the clutch disengaged, engine speed is no longer tied to the wheels, so the car can stand still with the engine running. | WP-CL: "the engine speed (RPM) is no longer determined by the speed of the driven wheels"; "The clutch is required for standing starts". |
| "PEDAL COMING UP · DISC SLIPS", shaft speeds up | Some slip, where the two shafts turn at different speeds, is needed when pulling away from rest. | WP-CL: slipping is needed when the vehicle "accelerates from a standstill", while wear should be kept to a minimum. |
| "GEARBOX SHAFT = n% OF ENGINE SPEED" | Computed from the drawing: the flywheel turns at a constant 6° per frame; the shaft's speed is drawn as a fraction of that (0% with the disc apart, rising while it slips, 100% when locked, coasting down after the pedal is pressed again). | Illustrative animation; the percentages are the drawn ratio, not measured data. No rpm values are shown. |
What the drawing simplifies
- Schematic side view, not to scale. Real clutches have a pressure plate, a release bearing and a diaphragm spring; the pressure plate is not drawn (WP-CL, as fetched, does not mention one).
- The shaft slowing down at the end is drawn as simple coasting; what slows the car is not shown.
- No quantities with units on screen, so no unit conversions.
Sources
Found an error?
Tell us at hello@workingshown.xyz or in the comments. We check it against the sources, pin the correction, fix the caption, and log it on the corrections page.
